Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

We offer DC / DC Units in the following variations

We build Special purpose SMPS units based on your requirements mail us at sales@nhpelectronics.com

Click Here to send your enquiry now

 

BATTERY CHARGERS

MODEL NO: BC 12V 10A - Download PDF

bc 12v 10a
  BATTERY CHARGER FOR ENGINE START APPLICATIONS. SUITABLE FOR CHARGING 12V-130/180AH BATTERIES
Click on Image to Enlarge

SPECIFICATIONS
   
Input Voltage 150-300 V AC
 
Output voltage  
Float Mode 13.4 V DC
Boost Mode 13.9 to 14 V DC
 
Inrush Current Limited by NTC Thermister
 
Charging current in boost mode 10 amps
 
Charging current in float mode 0 to 4 amps
 
Operating Temperature 0 TO 50 DEG C
 
Leakage current <2 mA  at 230 vac
 
Vibration 10-500 Hz 2G 10 min/1cycle 60 mins each along XYZ axis
 
Protections
Input under voltage Cutoff level 140 VAC. Turn on voltage 160 VAC
Input over voltage 300 V AC units shuts off if voltage goes above this value
Output over voltage (Batt charger included) 15.5 V DC
Output short circuit and overload Continuously protected
Battery reverse polarity Protected latching mode
 
Current drawn by charger from battery Draws zero current from the battery under any circumstances
 
Externally Induced Over voltage Protected against output overvoltage caused by parallel connection of alternator etc
 
Annunciation Potential free NO /NC contact for charger On/ Fail indication
 
Indication Mains On, Float, Boost, and Battery Reverse
 
Line Regulation <1%
 
Load regulation <1%
 
Ripple and noise 150 mv p-p
 
Isolation between: Input & Output 2000V AC
 
Input & Earth 1500V AC
 
Output & Earth 1500V AC
 
Dimensions: L*B*H 170*110*85mm
 
Mounting Wall mounting type
 
Weight 1200 gms
 


Back to Top